Pc Lap Counter

Logiciel de comptage
 
HomeHome  FAQFAQ  SearchSearch  RegisterRegister  MemberlistMemberlist  UsergroupsUsergroups  Log in  

Share | 
 

 Analogue pit stops

View previous topic View next topic Go down 
AuthorMessage
rich1969411



Number of posts : 2
Registration date : 2012-05-30

PostSubject: Analogue pit stops   30/5/2012, 12:51

Hello I have recently purchased PC Lap Counter, but I am struggling to get the pitstops to work in an analogue format.

I have a 6 lane track with a DS300 Lap Counter with a 6 lane DS Gantry.
I have followed your guide on using parallel port for pit stops but I can't seem to get the pit stop to start.
I presume the input pins to be used are the same as the ones used for lap counting?

Please excuse me if I have missed something obvious.
Thankyou
Back to top Go down
View user profile
guy

avatar

Number of posts : 2058
Localisation : Belgique
Registration date : 2006-01-25

PostSubject: Re: Analogue pit stops   30/5/2012, 18:06

First thing to do is to check the input pins state with the parallel port monitor , check if the state of the input pins change when a car stay on the sensor.
Back to top Go down
View user profile http://www.pclapcounter.be
rich1969411



Number of posts : 2
Registration date : 2012-05-30

PostSubject: Re: Analogue pit stops   30/5/2012, 21:05

no the pins data dosn't appear to change when the car stays over the sensor.
But it does register laps
Back to top Go down
View user profile
guy

avatar

Number of posts : 2058
Localisation : Belgique
Registration date : 2006-01-25

PostSubject: Re: Analogue pit stops   30/5/2012, 21:53

Just to understand your track configuration: to register laps you have your DS300 and a DS bridge but what kind of sensor you use for pit stop , i assume you have connected supplementary sensor to the parallel port of your computer or not ?

rich1969411 wrote:
no the pins data dosn't appear to change when the car stays over the sensor.
that's the problem !

rich1969411 wrote:
but it does register laps
So you have a double lap register ?
If you register the laps by using the DS300 then in the LPT1 interface of Pc Lap Counter you have to tick "Sensor's connected to input pin are used only for pit stop detection" (in the PitStop tabpage)



Back to top Go down
View user profile http://www.pclapcounter.be
Sponsored content




PostSubject: Re: Analogue pit stops   

Back to top Go down
 
Analogue pit stops
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Hi from Steve at Brit Stops
» Front Suspension Bump Stops
» rubber stops on holden vans
» Obama stops soldier from speaking...
» Starts, stutters and stops - sometimes....

Permissions in this forum:You cannot reply to topics in this forum
Pc Lap Counter :: General-
Jump to: