Pc Lap Counter

Logiciel de comptage
 
HomeHome  FAQFAQ  SearchSearch  RegisterRegister  MemberlistMemberlist  UsergroupsUsergroups  Log in  

Share | 
 

 Newbie question about LPT settings

View previous topic View next topic Go down 
AuthorMessage
lars_jacobsen



Number of posts : 92
Registration date : 2006-10-02

PostSubject: Newbie question about LPT settings   2/10/2006, 23:40

Hi there
I have just downloaded the demo of your software and is seriously considdering buying this product - do however have a couple of questions

We plan on using the Parallel port for the sensors building our own cable - this is quite simple, but my question is - if i buy the power relay hardware from dentronics will i have to connect the sensors to this as well or are they using different pins? (building a 4 lane track and want to have sensors + power control)?

Looking forward to hearing from you

:-)
Back to top Go down
View user profile
guy

avatar

Number of posts : 2046
Localisation : Belgique
Registration date : 2006-01-25

PostSubject: Re: Newbie question about LPT settings   3/10/2006, 10:36

Dontronics box use only output pin (2,3,4,5,6,7,8,9).
To use sensor on parallel port with dontronics box for power control you have to make a special cable that separate input pin (pin used by the sensor) and output pin.
I make it for my home track and it's very simple to make a Y cable (male and two female) , one female taking pin 10,12,13,15,25 (for sensor) and other female taking pin 2,3,4,5,6,7,8,9 for dontronicx box.

cheers
Back to top Go down
View user profile http://www.pclapcounter.be
 
Newbie question about LPT settings
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Newbie question abt getting handicap
» Newbie question - Lifespan of a Driver
» newbie question - Is there some direct way to measure OIL level?
» A newbie question !
» Newbie question on driver shaft length

Permissions in this forum:You cannot reply to topics in this forum
Pc Lap Counter :: Hardware :: Parallel port-
Jump to: