Pc Lap Counter

Logiciel de comptage
 
HomeHome  FAQFAQ  SearchSearch  RegisterRegister  MemberlistMemberlist  UsergroupsUsergroups  Log in  

Share | 
 

 Power control during fuel management

View previous topic View next topic Go down 
AuthorMessage
GVriese



Number of posts : 1
Registration date : 2008-01-27

PostSubject: Power control during fuel management   27/1/2008, 12:32

I found the setting in PCLC to control the power during refueling and the setting that generates a Pit-In signal after the car is on the sensor for x seconds, and a Pit-Out signal when the car leaves the sensor.

Is it possible to set up PCLC to reactivate the power when the Pit-In signal is lost? The system I am looking to create would allow the driver to make a race time decision to only take on partial fuel. This would be helpful towards the end of a race/segment when the partial fuel will be enough to last until the end of the race/segment. The driver could save valuable seconds by not wasting time to get a full fuel tank.

In order to do this the driver would have a switch on the driver station to interrupt the Pit-In signal to PCLC. But PCLC must, of course, reactivate the power when the Pit-In signal is lost. Does PCLC do this, or not?

Doei!
Back to top Go down
View user profile
guy

avatar

Number of posts : 2056
Localisation : Belgique
Registration date : 2006-01-25

PostSubject: Re: Power control during fuel management   27/1/2008, 19:52

As soon the option "My system send Pit in event" is ticked you don't need to set power off during refueling period because it is the driver who decide when he enter into the pit and when he leave it and so in that case the option "Set lane power OFF during pitstop and ON after refueling" should be unticked.
In final version 4.46 i will disable the option "Set lane power OFF during pitstop and ON after refueling" when the option "My system send Pit in event" is ticked.
Hope i help you scratch
Back to top Go down
View user profile http://www.pclapcounter.be
 
Power control during fuel management
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Accessory Power and Fuel Pump, Where?
» What fuel management programmer is the best bang / buck?
» FAQ: How to tune the PCM? (Series II SC)
» fuel pump wiring
» Sargent EC155 Power Control System problem

Permissions in this forum:You cannot reply to topics in this forum
Pc Lap Counter :: Race Setting - Config courses-
Jump to: